Re: 4020 gauges

Posted by Bob on April 01, 2007 at 23:33:56 from (69.178.229.154):

In Reply to: 4020 gauges posted by Chuck H. WI. on April 01, 2007 at 21:50:31:

What does the voltage read across the two batteries with the tractor running?

IIRC, it"s supposed to be about 29 Volts.

The gauge should be powered by (-) 12-Volts (nominal), in relation to the chassis.

As you alternate between grounding the wire to the sender to the chassis and not grounding it, the gauge should alternate between empty and full.

You can"t just pull the sender out of the tank and expect the gauge to move as you swing the float. the sender has to also be grounded to function.

There are gauges for (+) ground systems and (-) ground systems, and, according to a guy that was working with a 4010 a while back, the parts system is confused as to what is what with the gauges.

You could go over to the KL Forum and ask for "Jim in AK", as he had some part numbers for the guage and sender that worked together on his 24-Volt system.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]