|
Tractor Talk Discussion Board |
Re: 4010 fuel guage
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Drill on March 24, 2007 at 07:13:45 from (161.184.196.219):
In Reply to: 4010 fuel guage posted by 4010rlw on March 24, 2007 at 06:46:43:
The fuel gauge system works on the ground side of the electrical system. When you ground out the sending wire the guage should go to "full". Most guages aren't that accurate any way. With the sending unit out of the tank connect the sending wire to the guage, run another wire from the sending unit to a good ground on the frame of the tractor, then move the float through its full movement and see if the guage follows it, if it dosen't then its probably the sending unit.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
