Tractor Talk Discussion Board |
WD-45 Loader Operation
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Rick Fanning on February 16, 2007 at 07:54:12 from (63.237.20.195):
Hi, I have recently purchased a used Paulson trip loader to put on my AC WD-45. I was told that teh hydraulics would attach to it via a hose run from the remote at the rear of the tractor seat and teed off to attach to each cylinder. No problem there, but I do have what is probably a stupid question. Do you then use the lift controls to move the loader frame up and down, or is there something I am missing from the setup? If you use the lift controls will the lift go up and down with the loader? Is there something on the pump that can set it to remote only? The WD45 manuals have not been much help on this. Thanks, Rick
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|