Tractor Talk Discussion Board |
Re: OT...? on Ford oil pressure sending unit
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BLW on January 26, 2007 at 08:49:25 from (4.156.138.223):
In Reply to: OT...? on Ford oil pressure sending unit posted by Steve Crum on January 26, 2007 at 08:28:17:
have fords for years- and hate to tell you-- the problem is prob. in the oil pump-- the last few years ford has made lousy pumps some of them only went 30K and did just what you are experiencing== put in heavy oil and I'll bet you the pressure comes back-- I don't mean to run it this way but it will tell you if it is in the pump or guage.. if it is a 2 wh dr not bad to change-- ///// another screwing by ford but they aren't the only ones ++ chevy with the overdrive tranny, dodge with the weak front end toyota with the rust and so on and so on wish you luck
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|