Tractor Talk Discussion Board |
(OT) 1990 2ton Yale Forklift Incher Question.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by doogdoog on January 24, 2007 at 16:19:47 from (75.80.223.143):
Aloha, I have a 1990 Yale 2 ton forklift and have a question on the "inching control" ckt. From my understanding, when the brake is partially applied, the clutch pack is suppose to slip a little to inch into the load and when the brake is depressed all the way, the trans. fluid is supposed to be diverted to the sump (no forward movement). Ok, I was on a slight incline (forks facing uphill) with the selector in the forward position (drive) and had the brake depressed all the way down and when I slowly let it out, the forklift started to roll backwards. It seems that the inching is not working correctly but when I let the brake out further (all the way out), it goes forward (which is normal). Could the inching valve be only half working?? TIA Mahalo, doogdoog
Replies:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|