Tractor Talk Discussion Board |
single bottom 3-pt plow
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tim, Ohio on December 27, 2006 at 09:30:47 from (128.146.239.246):
Everyone, Just wondered what there is to know about using a single bottom 3-pt plow. I am considering buying one to do our garden plot. Until now we have simply used a rototiller, but now I am interested in going a little bigger with the plot and applying manure or green fertilizers. I intend to use one of my two Ford NAA tractors to do the work. I noticed a single bottom plow for a class I hitch is available from TSC for 470.00. Do you think this would give me enough years of use in a small garden plot application? Since I do not have a disc, I plan to break up the plowed area with the lowered tines of my box blade (which has worked in other applications) Then, go over it with my rear tine rototiller. Any thoughts or suggestions appreciated. Tim, Ohio
Replies:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|