|
Tractor Talk Discussion Board |
U.S./Canada Border crossing.. How It Is Here
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by migraine on December 19, 2006 at 21:44:20 from (71.231.54.158):
Responding to the post down below but was getting kind of long so.. the border is very very tight and cameras have been set up all along the border that can spot ANY movement with night vision as well. Everything and everybody goes through the border crossings some of which are open 24 hours, some not. No more laying down the planks and jumping the ditch a minute. They will have you in two minutes or less and no one will know where they took you. This is NW Washington and our little town is 3 miles from the border This is the place where they discovered the tunnel dug under the road from a greenhouse to an old farm house on the U.S side and they must have worked more than a year digging out the dirt and installing plywood sides and roof of tunnel. The four lads are sitting in a very dark place now waiting to hear their fate. we always take our original birth certificates and licenses and must have a parental permission slip if we are carrying the grandchildren. We probably cross the border once a month and you just act calm and only answer the questions you are asked. No more no less. If you are bringing farm machinery across the border you best have all and I mean all dirt, weeds and chemicals removed for inspection. You can bring old tractors and machinery and parts across either way but best have sale bills if you just bought them or have an address if you plan to leave them. I got turned away at the border trying to return some wood pallets for 3 bucks apiece back to Canada because I might be carring some foreign material in the wood or have some preservative or chemical residue on them. No flowers or plants can come across here without Gov't inspection and certificate. We've left more than one bouquet at the border!! Since 911 it is so tight here that you best make sure that the vehicle you are driving has clean plates and your driving record is clean cause when they flash that picture of it in the lineup it will show them everything about you and yours for the last 10 years. sorry i got to rambling what else do you want to know? Migraine
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|