Tractor Talk Discussion Board |
Re: jeeze.. too many $$$$
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by dr.sportster on October 24, 2006 at 14:12:32 from (67.72.98.81):
In Reply to: jeeze.. too many $$$$ posted by Tim Shultz on October 24, 2006 at 09:45:46:
My freind had a 62 Galaxy.He kept the same pistons after checking compression.So no lower end job.We put in an Isky cam and some headers I bought for my 59 T-bird but never used.We never took the engine out of the car.We did pull the heads and relapped the valves[no valve equipment]and put on new seals.The car ran quite strong.This was around 1986 and I have no idea which Isky cam we used.Anyway if you dont have to do the lower end you save alot of cash.390 is an FE series Ford motor and there is a good book on them called How to Rebuild Your BIG BLOCK FORD.My T-bird had a 352 cubic inch Big block with 390 heads and aluminum Ford intake manifold,stock Holley carb.There is alot of FE series speed parts at car swap meets also.Good luck with your motor keep some info posted.
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|