|
Tractor Talk Discussion Board |
Re: Temporary movable elecric fencing
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by hayray on October 23, 2006 at 10:55:58 from (216.234.125.43):
In Reply to: Temporary movable elecric fencing posted by CB in central NY on October 23, 2006 at 08:08:59:
I use temporary fence alot and I agree with Cowman, you need a real good ground and extra ground rods on a permanent location so the charger is always well grounded with changing moisture conditions, I have seen chargers where you needed to put 11 rods in to make it work right. I also would forget the ribbon fence and use poly wire instead. The ribbon fence has to be spliced together with a joiner to keep the ends from twisting together and burning up and shorting out the system, not very practical. The battery powered chargers and the solar chargers I have never seen hold up to the standards of the 110 and the 220's. Also, buy good polywire, don't go to the local co-op or Tractor Supply and buy that crap, it will end up tearing apart and breaking in several places after hanging for a month. The good stuff, I buy Ghallager brand fence out of New Zealand, and it last a good 6 years and is great stuff, I have a local dealer so that helps me out. I also use the push in steel rod post with a fiberglass pig tail, they last for years as oppossed to the plastic ones, and I use the 2 inch fiberglass post and strain insulators for corners.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|