|
Tractor Talk Discussion Board |
Temporary movable elecric fencing
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CB in central NY on October 23, 2006 at 08:08:59 from (63.162.143.21):
Brought on by the other post about electric fences...
I apologize in advance, I am new to eletric fencing.
My pastures (beef cattle) are fenced in with non-electrified woven wire fence. I do not want to electrify the whole thing but would like to do rotational grazing (grass-fed beef operation). I have seen advertised fence controllers designed just for that - they will power about a mile or two of fence and run on D-batteries or a car battery. I can see stringing a single strand or a ribbon of fence across the pasture with one of these and just moving it up as the cows graze off the section. My question is: how do you ground it? I can"t see actually driving rods every time I move my temp. line, especially if you have to use more than one. Is the ground somehow incorporated into this controller? It does look like you can actually stick one of these units in the ground on a shaft provided with it. Thanks in advance for the help.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
