|
Tractor Talk Discussion Board |
Re: 4020 12v/24v system
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by nickg on October 19, 2006 at 08:11:35 from (24.51.124.116):
In Reply to: Re: 4020 12v/24v system posted by Bob on October 19, 2006 at 07:17:31:
I looked at the wrong number. I have 620 cca. I also just had my starter tested and it was bad. i am hoping this solves one of my electrical problems. I am still a little confused though on how the 12v side grounds to the tractor frame. My 66 does not have any other wires coming off the batt except the ones connected to the starter and the one that hooks the + of one to the neg of the other. I am sure I have a ground issue do to none of my lights work until I ground the lights to the frame with a short jumper I use for testing
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
