Tractor Talk Discussion Board |
Re: Ford 9N Oil Filter...Is it supposed to have on
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob on October 06, 2006 at 00:41:26 from (69.178.229.154):
In Reply to: Re: Ford 9N Oil Filter...Is it supposed to have on posted by Gerald J. on October 05, 2006 at 13:38:40:
Gerald, that's 100% bullpuckey!!! Where did you get an idea like that??? The "N" Ford's oil pressure regulator valve, located at the front of the engine dumps any excess oil into the timing gear area, where it returns to the crankcase.
The bypass filter is fed oil from the main oil gallery at the REAR of the engine, and a simple (tiny) oriface limits flow OUT of the filter canister, so that only a small amount of oil flows through the filter assembly, so as no to drop the engine's oil pressure too much. AFAIK, ALL the 9N's, 2N's and 8N's would have had oil filters, from the factory. Originally, the filtered oil was simply dumped into the crankcase. At some point, a change was made where the return oil from the filter was piped to the other side (RH) of the engine, where it was returned to the crankcase through the governor, lubing it on the way.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|