Tractor Talk Discussion Board |
Re: Ford 9N Oil Filter...Is it supposed to have on
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Gerald J. on October 05, 2006 at 13:38:40 from (67.0.97.230):
In Reply to: Re: Ford 9N Oil Filter...Is it supposed to have on posted by Steve Bowling on October 05, 2006 at 13:28:53:
As I remember the filter on the 8N I had, it was made by a filter maker and like the filter on the Continental engine in my standby generator is plumbed into the engine with steel tubing and standard fittings. Maybe a Fram C3 filter housing. Check a GOOD filter catalog (not at walmart) and you should still see the filter housing is available. A bypass filter only sees the oil that is released from the pressure lines by the oil pressure regulator valve. The main oil flow goes directly from the pump to the bearings. The excess goes to the bypass filter. Its not as good as a full flow filter that is the modern standard, but it was much easier to retrofit to an engine and was better than no filter at all. Gerald J.
Replies:
Home
| Forums
Today's Featured Article -
Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|