|
Tractor Talk Discussion Board |
Fuel in oil
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by oldcraneguy on August 26, 2006 at 09:50:07 from (70.156.225.100):
Im about to buy two small JD's one with a 2cyl yanmar and the other with a 3cyl. according to the guy thats been maintaining these machines they both put fuel in the oil. he says its always a injection pump seal on those yanmars. My question is, is this true? is it common with yanmars? and how big a deal is it to reseal a pump? I remember working on some cat engines that had to have a specific tool for each different model engine to time the pump when reinstalling it...neither one of these engines have more than 1400 hrs on them and I dont think he even checked for any other possibilties...do yanmars run fuel thru the heads or have anything like jumper lines like a detroit? or is the fuel system isolated other than where the drive goes into the case?
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Engine Basics: Spark Plug Cleaning - by Staff. Cleaning procedures: Brush or blow dirt from around the spark plug base. Remove the plug with a correctly fitted wrench. Examine the porcelain insulator and points. If the insulator appears to be melted or blistered, cracked or broken, and the points seem unduly burned it is evident that the plug is operating too hot and it should be replaced with a colder plug. If the plug is fouled excessively with carbon it apparently is operating too cold and it should be replac
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
