|
Tractor Talk Discussion Board |
Are all NH Haybine 467s the same?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Isidore Flores on August 22, 2006 at 17:31:38 from (165.95.154.143):
In Reply to: Re: Will a Haybine work for me? posted by roper6365 on June 11, 2005 at 13:12:22:
I just bought one and I can't figure out how to adjust the roll pressure. The picture [and directions] in the [shabbily copied] owners manual do not match the machine in that the roll tension adjustment bolt does not exist, nor a hole for it! Maybe there are parts missing [there is a threaded stud sticking out that is not shown in the manual picture either] or there was a change early in the model run that was not reflected in the 22 page manual that came with the machine [serial # 111135]. NH customer service and the local dealer are no help. May I please trouble someone for an opinion?
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
