|
Tractor Talk Discussion Board |
Don't Ask Me
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Allan In NE on August 01, 2006 at 20:47:14 from (148.78.243.25):
Hi Guys, Fight is over! Darned tractor blew a head gasket. Okay, fine. Took the head off, sent it to the machine shop, emptied the bank account until the teller glared at me to get the head back out of hock, put 'er on and the tractor won't run right. Just knew the darned valves were stickin' in the guides. I've had it happen before. Sure didn't want to pull that head again so I started doing some checking. Wait a minute! The darned old rascal has compression! If the valves were hangin' she wouldn't have any wind to speak of. Okay, time to stop cussin' the machinist. More checking. Say, that spark just doesn't look right. Check it at the coil tower and it just isn't consistant on the secondary. Aw ha! Must have a bad coil, 'cause I just put in a new pick-up ignition system a couple of months ago. So, we put a new coil on and no joy. Same darned thing, 'cept now it doesn't run at all. Now, hold the phone. The darned tractor was running like a million bucks 'til it blew that head gasket, what the heck is going on? Bottom line, solid state ignition went belly up. Put the points back in and it purrs like a kitten. I have no idea why either. What ruined the ignition? :>( Side note: Darned camera is quick. That engine was running at about 1,000 rpm when I snapped the picture. Stopped that fan and rockers in their tracks. :>) Allan 
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
New Hitches For Your Old Tractor - by Chris Pratt. For this article, we are going to make the irrational and unlikely assumption that you purchased an older tractor that is in tip top shape and needs no immediate repairs other than an oil change and a good bath. To the newcomer planning to restore the machine, this means you have everything you need for the moment (something to sit in the shop and just look at for awhile while you read the books). To the newcomer that wants to get out and use the machine for field work, you may have already hit a major roadblock. That is the dreaded "proprietary hitch". With the exception of the
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
