|
Tractor Talk Discussion Board |
Re: 12 volt conv.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob on April 11, 2006 at 17:57:07 from (64.21.249.40):
In Reply to: 12 volt conv. posted by DAVE DAHL on April 11, 2006 at 17:35:53:
This is a photo of a 10SI alternator with the #2 terminal jumpered to the large output stud. 
The wire from the #1 "switched excite" terminal has a 1N5008 diode in it, and would be connected to the switched side of the ignition switch. If the tractor has a magneto, an oil pressure switch can be used to power the
"switched excite wire" only while the tractor is running (and has oil pressure to turn the switch on). A 10 Ohm 5 or 10 Watt resistor can be used in place of the diode, or a # 194 lamp, or lamp of equivalent current draw can be used, as well. Also, see BobM's diagrams, at the link below:
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
History of the Field Marshall Tractor - by Anthony West. Any restorer who has some knowledge of turn of the century farm machinery, will recognize the name Lanz Bulldog!! This machine was to say the least unusual in its appearance. The huge flywheel and coffee percolator shaped exhaust. Along with square body lines and cylinder head protruding forward of the front axle. Would become the visual differentiation that people would quote to separate the Lanz from other period machines. The Marshall company based at the Briannia Works in Gainsborough
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
