Tractor Talk Discussion Board |
Re: Just Don't Get It
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John (C-IL) on February 10, 2006 at 17:15:48 from (205.188.117.14):
In Reply to: Just Don't Get It posted by Allan in NE on February 10, 2006 at 07:40:23:
With the bearing cage on the inside the lateral load on the bearing is transfered to the frame of the baler. If the cage were on the outside all of the lateral load would be transfered to the 3 bolts and the metal of the cage and frame around those bolts. I have seen too many of those cages that were busted up from the lateral loads, especially augers on a combine like the Gleaner unloading auger in particular.
Replies:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|