|
Tractor Talk Discussion Board |
Just Don't Get It
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Allan in NE on February 10, 2006 at 07:40:23 from (148.78.243.26):
Mornin' All, This one woke me up out of a dead sleep last night 'cause I thought I would have to "redo". I tend to run my chores over and over in my mind so that when I do something, I don't make a mistake. Today, I'm aligning and locking all the bearings I've replaced in this old baler so that they all run straight and true. When I replaced this bearing on the stripper roll, I found it odd that it was "caged" inside the bale chamber. This means that in order to replace this bearing, the whole darned roller has to be removed and pulled out the other side of the baler so as to gain access to this bearing. Thought maybe since the old sister is 30 years old that someone, somewhere had replaced this bearing and had done it "wrong". Checked and rechecked. Book shows it inside the machine also. Why in the heck would an engineer place a bearing "inside" like this? They must of had a reason, but darned if I can see what it was. :>( Allan 
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
