|
Tractor Talk Discussion Board |
Re: Farmall F-20
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by josh in indiana on February 07, 2006 at 21:27:09 from (12.208.56.205):
In Reply to: Farmall F-20 posted by ChuckIH on February 07, 2006 at 18:38:50:
Chuck, Is the mag impulse making a good strong snap as you roll it over? If it isn"t then I would suspect mag problems. Also, did you file the points? Those old up draft carbs can be a real bear to get fully primed. On my 20 I usually have to pull it to start it when i try it for the first time after winter. It sometimes takes a fair amout of pulling too. Gas can be leaking out and I will still have to do this. Sometimes its just the nature of the beast. The Nebraskacowman is very knowlegable about thos F20"s and he ca help ya out lots. Good Luck Josh in Indiana
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|