Tractor Talk Discussion Board |
Re: tractor shed
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CLW on January 03, 2006 at 23:18:20 from (68.94.179.127):
In Reply to: tractor shed posted by chuck t on January 03, 2006 at 16:26:39:
chuck, I set poles for about 12 years for the phone co. 25 ft. was as short as we used and in most cases they were set 5 ft. deep. You will not need to go that deep since they will be braceing each other. Still 4 ft. would give you 13 ft. out of the ground. Kevin gives good advice in his reply. We had sidewalks poured around some and the life of the pold was cut to 12-15 years becouse it would rot at the base. One thing you want to check if you use a chainsaw is to check for nails. If the poles were used in town they will have nails where people have put signs on them. One will do in a chain in 1/2 a second. CLW
Replies:
Home
| Forums
Today's Featured Article -
Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|