|
Tractor Talk Discussion Board |
Muffler stack
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Shep Va on November 14, 2005 at 07:29:43 from (68.152.9.254):
I am looking for a chome stack for a tractor with a 90 degree bend on the top that has some muffling abilities. I like to look of the chrome stack on the tractors, but my ears hurt from the loud engine with the streight pipe. I dont have enough room for an under hood muffler and I hate having a huge muffler to look around on the hood. I talked to a big rig place that sells "stack pacs" but they are only aluminized not chrome and I doubt that paint will stick to the pipe. I thought about putting the stack pac in and putting a chrome pipe over it, but that could rattle or may not stay put. Any ideas where I can look for a muffler stack?? Thanks
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|