|
Tractor Talk Discussion Board |
Wisconsin V4
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by J Kelnhofer on September 29, 2005 at 19:00:38 from (69.64.132.187):
Need Help. Bought an old 610 bobcat with the v4 wisconsim motor and it wont run quite right. It Idles great and starts no problem. Will idle for about 20 minutes before it kills. When I ope it up it runs for about 40 seconds before it kills like I just shut the key off. I checked the filter,(actually I just bypassed it quick cause I did not have new filter), all the lines are clear, It has mechanical fuel pump and it pumps fuel awesome, line between pump and carb is clear. I'm assuming carb is fine cause it runs good for a while. So then I thought maybe the coil, so I borrowed the coil off my 630 case and it still does the same thing. Any Experts that can give me some other Ideas? Thanks in advance. - Josh K
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Horsepower Defined - by Staff. Indicated Horsepower This represents the power developed in the enine cylinder as obtained from the pressure in the cylinders. This is pressure obtained from an indicator which shows cylinder pressures. Indicated horsepower does not represent the actual useful power delivered by the engine. Brake Horsepower This is the actual horse power delivered by the engine to the shaft. It is equal to the "indicated horsepower" less the friction of the engine. It is useful hor
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
