|
Tractor Talk Discussion Board |
My Own Worst Enemy
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Allan in NE on July 10, 2005 at 04:46:45 from (148.78.243.26):
Mornin' All, Oh, oh. I was trying to be clever and took a very wrong turn, me thinks. :>) What is the metric size bolt that is 'just smaller than' a 1/4" inch? Is it 8 mm? Anyway, while I'm waiting on the hay to dry, I decide to R&R the sheer bolt assy from my baler and drill 'er out so that I can just use plain old 1/4" bolts instead of the New Holland packaged sheer bolts. Wrong. Ya don't drill this stuff; it must be case hardened, 'cause even on the drill press, I can't touch it and have been thru 5 drill bits. Dumb me. Gotta go buy a bunch of bolts from the local tractor outlet before I can get to the field this morning. New Holland dealer is toooo far away. :>( Allan 
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Storing Your Tractor - by Staff. If your tractor is going to be stored for any length of time, a few precautionary measures are helpful in preserving various parts, also in avoiding future difficulty. Store tractor under cover. If impossible to place tractor under cover, be sure to cover air stack and exhaust pipe. Drain radiator and engine block. To avoid gum content collections, drain both fuel tanks and carburetor. Leave radiator and fuel caps slightly loose to protect gaskets. Block tractor up to remove weight from tires and to keep tires from contact with moist floor.
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
