|
Tractor Talk Discussion Board |
Re: Another oil question....
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by txgrn on June 12, 2005 at 07:16:12 from (209.151.118.135):
In Reply to: Re: Another oil question.... posted by Stan(PA) on June 11, 2005 at 12:06:37:
If you look at a viscosity curve vs temp on oils, a straight weight oil will solidify at a certain low temp and flow like gasoline at a certain high temp based upon it's "weight". Higher the number the higher the curve shifts up in viscosity (thickness vs temp). The thing oil companies are trying to achieve with multiviscosities is to alter the oil's drastic viscosity change so that you can lower the temp where the oil solidifies and raise the temp where it runs. The thicker the oil the higher the oil pressure. Hence when oil is cold it is thick and you get high pressure. When it gets hot the difference is true. Multiviscosity oils flatten out this curve and keep it thinner cold and thicker hot. Also, as mentioned, your engine bearings open up as temp goes up and they aggrivate the oil pressure problem. I ran an experiment on a MF 35 with a Perkins 3 cyl diesel. I didn't like the oil pressure variance from the time I started it till I had finished using it. It had a lot of wear on the engine and obviously the big change wasn't all the oil's fault. I put in 15w-40 diesel oil and straight 40w. Obviously the curve was higher on the straight weight oil and I had higher oil pressure the whole time. Problem is, this winter the 40w will be jello and I willl have to change to the thinner oil. That means two seasonal changes which I am not going to do. So I returned the multiviscosity and tolerated the slightly lower oil pressure. Mark
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|