NH 311 hayliner knotters

Posted by Hurst on June 02, 2005 at 16:10:00 from (204.255.227.72):

We had some trouble with the knotters, as in the sheer bolt for the knotters sheered along with teh main one. Well, the knife on one side broke, so we replaved that, but now the little fingers that grap the needle are out of time, like they just jumped the gear. What would have caused this and how do I get it to jump back to where it was supposed to be? I have tried crowbar, screw driver, etc. The problem is that the flat side of the gear is going through the gears too soo, so when it gets to the flat part of the wheel, it is riding in the gear teeth. Also, should these parts be able to movie back and forth about 1/8th-3/16ths of an inch? Thanks for your help.

Hurst

Follow Ups:

• Re: NH 311 hayliner knotters RickB 17:32:11 06/02/05 (0)
• Re: NH 311 hayliner knotters KEH 17:01:53 06/02/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]