|
Tractor Talk Discussion Board |
Re: O.T. I have problems with a zipper on my cover
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by buickanddeere on December 25, 2004 at 21:57:52 from (64.10.41.84):
In Reply to: Re: O.T. I have problems with a zipper on my cover posted by Davis In SC on December 24, 2004 at 18:43:28:
The past couple of days have been awful.
A neighbour lady was running late and got stuck in our yard after running off the laneway into the snow a couple of days ago.
Wasn't too bad at the time; digging, dragging the chain and sitting on the tractor seat while towing & running the snowblower afterwards.Still felt OK while noticing the critter's feeders were now empty after last filling them just before surgery. I didn't think that feed pail was too heavy until picking it up. Felt not one but both sides"give".
Then yesterday & today got dragged off to family events. Too much walking again and not enough chances to ice down the previous days over exertion.
I thought the gonads were only swollen a little but the wife said dream on, they are almost twice the normal size.Zero sympathy from her as well. And that &^%&*(& "support" they supplied and then send a bill for is just a jock strap. Now just to add insult to injury there is a rash and jock itch as well.
The horror stories about these people who over do it too soon are too true. I have mixed feelings about mercy killings, to end suffering right about now would be worth nearly any price.
In brief, follow the Dr's orders to the letter no matter what.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
