|
Tractor Talk Discussion Board |
Re: Posting..is this another Scam..????
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on September 28, 2004 at 15:42:03 from (66.163.134.177):
In Reply to: Re: Posting..is this another Scam..???? posted by BobR on September 28, 2004 at 15:10:11:
Yes, there is a way to stop them. When we all quit being greedy, hoping to get something for nothing, and a little light bulb goes on in everyone's head that if something seems to be too good to be true, it most likely is! Once this happens, and everyone just ignores the scammers, and there is no ill-gotten profit in it for them they'll quit wasting their time sending the scam emails! Just like the telemarketers... they had enough people respond, and buy from them that it was a profitable endeavor, even though most people seem to HATE telemarketers calls. If no one would have bought from them, they would have shut down years before the government put the clampdown on them, if there ceased to be a profit in it. So, lets all IGNORE the scammers, and they'll go away! (Eventually!)
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
