|
Tractor Talk Discussion Board |
Re: What gives
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Paul in Mich on July 02, 2004 at 07:24:30 from (68.188.227.110):
In Reply to: What gives posted by Duane on July 01, 2004 at 13:52:40:
Duane, If what the dealer told you were true, wouldn't semi's have the 5th wheel pivot point behind the rear axle? I think you'll find that they are positioned 2/3 to 3/4 tward the front drive axle on tandoms, and in front of the axle on single rear axles. I would first check with Texas D.O.T., and then if they can quote no law prohibiting the hitch from being directly over or slightly ahead of the axle, confront the dealer and ask him to show you such law, and if he can't, make a big scene right in front of customers, which usually gets their attention. The whole reason for having the fifth wheel over or ahead of the axle is so that the load does not take weight off the front wheels which in turn affects steering. Try going around a corner, or negotiating an on or off ramp with the front wheels barely biting the pavement, and see the crowd gather after you lose it. It just doesn't make logical sense, and worse it becomes a safety issue. Also, unless there were pre drilled mounting holes in the bed, I would make them replace the bed at their cost. As stated in previous threads, the dealer is CYA mode. That still doesn't make him right.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Ford 3-Point Single Bottom Moldboard Plow with Coulter
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|