Re: Repair of Egged-Out Fittings.

Posted by been there, done that on June 09, 2004 at 23:22:57 from (67.131.165.58):

In Reply to: Repair of Egged-Out Fittings. posted by bbott on April 12, 2000 at 17:07:39:

I melted down some old engine bearings for the babbit and poured it around the pins to tighten up an old 310a backhoe, slid the pins out and drilled the alemite holes out and replaced the alemites and greased er' up. Under normal use it lasted me 6 months or so in the high weight bearing apps and am still using it in the lighter applications. At the strongest leverage points It got sloppy fairly quick. Probly best to drill and put new bushings into action here.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Re: Re: Repair of Egged-Out Fittings. Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]