|
Tractor Talk Discussion Board |
Re: Re: Very OT - 0W-30 oil
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RAB on June 09, 2004 at 14:44:40 from (195.93.34.11):
In Reply to: Re: Very OT - 0W-30 oil posted by txblu Rest of story on June 09, 2004 at 12:13:38:
txblu - just apoint about your post. You do not necesarily need pressure to pump oil. If there is a big hole lots of oil may flow, but no pressure will be indicated. On the same level, no oil would flow, even at maximum pressure if a valve in the line was turned OFF. From all this we must conclude that pressure developed in the system only causes less oil to flow.
So, point made that pressure is not flow, we are left with the makers spec for that particular engine to achieve flow to all relevant parts. That is why they also supplied an oil spec. at the time of manufacture.
Just makes life difficult to compare new technology with the old in the original specs.
Regards, RAB
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
More Memories of a Field Service Engineer - by Brian Dye. Introduction: The author worked for one of the largest Ford tractor dealerships in England as a trouble-shooter on tractor engines, hydraulics and combine harvesters from 1963 to 1972. In 1972 he became a dealer manager and finally left the dealer net in 1975 to run his own electronic design and manufacturing company. [Editor] We live right in the middle of Norfolk. The dealership that I worked for sold Fordson Tractors from the 1920's and some of t
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
