|
Tractor Talk Discussion Board |
Re: Very OT - 0W-30 oil
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by txblu Rest of story on June 09, 2004 at 12:13:38 from (199.46.199.233):
In Reply to: Very OT - 0W-30 oil posted by Ron on June 08, 2004 at 16:10:50:
I just came from www.mobil1.com and read the ad for 0-30 and also Delvac Super 15w-40. The 0-30 happened to mention ......."where this viscosity is recommended" and the Delvac said" specially formulated for heavy duty diesel engine service". Curiously enough, there were OEM engine mfgr's approvals of the Delvac super in 10w-30 and 15w-40. All HD diesel engine mfgr's recommended the 15w-40 for their engines, but several declined to recommend the 10w-30. There's a message there. So while I'm pondering the question of surface tension and what relationship viscosity breakdown has to an engine, I realized that with 0 psig of oil pressure the oil will NEVER LEAVE THE PUMP. You have to have oil pressure to get the oil to circulate. So for worn engines whose tight bearing tolerances are no longer tight, you need viscosity retension to keep the oil thick enough to pump and thick HD oils do just that. Just proved it again last week on a '64 worn out MF 35 diesel as posted on this site. my 2c. Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
