|
Tractor Talk Discussion Board |
Re: Re: Re: Ford 2610 Diesel wont start
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by greenbeanman on May 12, 2004 at 07:13:39 from (4.244.81.7):
In Reply to: Re: Re: Ford 2610 Diesel wont start posted by C.A. Dennis on May 11, 2004 at 20:10:26:
To prime an engine, which may be a little bit of a misnomer, you use the hand pump on the injector pump. All it usually takes is a few strokes to force the air out. You should feel resistance when the system is primed. Since the tractor is turning over I assume it is out of gear, and that the PTO is disengaged. I don't think they will even turn over otherwise.
If it will turn over with it in gear or with PTO engage, then perhaps there is a fuel cut off safety feature. Since a diesel relies on compression for ignition, it has to be a fuel problem or an air intake problem. My bet is fuel if not some safety feature. Keep us posted please.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
