|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: Ford 2610 Diesel wont start
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by bstrucker on May 13, 2004 at 04:49:16 from (4.157.20.159):
In Reply to: Re: Re: Re: Re: Ford 2610 Diesel wont start posted by RickB on May 12, 2004 at 16:05:31:
Check to be sure you have fuel getting to your filter.If there is not a hand primer in the system you need to crank the engine.There should be bleed screws on your injector pump,usually 2,1 high and one low.When you crack them and crank the engine you should get fuel out of them.You should get fuel there even if there is a problem with the shutoff.If you get fuel out of the bleeds the tighten them and crack the lines at the injectors,when you start to get fuel from each one tighten them back up and it should start.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Ferguson TO-20 - by Staff. When the infamous "Handshake Agreement" between Henry Ford and Harry Ferguson fell by the wayside (that's a story in itself), Harry Ferguson quickly set up manufacturing plants for a United States version of his English TE-20. The TO-20 was relatively the same as the TE-20 except utilized some different casting materials and had a US-style electrical system. The TO-20 was a dead ringer for the Ford 9N and 2N models and they say that Ferguson did this on purpose when the Handshake Agreement wen
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
