|
Tractor Talk Discussion Board |
Re: Needing a John Deere mechanic help.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark on March 28, 2004 at 07:40:14 from (209.151.113.246):
In Reply to: Needing a John Deere mechanic help. posted by Dan on March 28, 2004 at 05:31:29:
My first quick check is battery voltage, but my batteries are side mounded and very easy to check. 12.75 volts is what I use for fully charged on an average temp day at least 12 hours after any charging operaton. Next if I turn the key and nothing happens, I have 2 choices. I either go back to the voltmeter and check the coil drive terminal at the starter solenoid (on top of my starter, the small term) or take a pair of common pliers and just jump across the big terminals on the same solenoid and see if I get an electrical racket and hear some kind of life, including an attempt at starting. What happens here determines if I chase down the big wire ckt or the small control wire ckt. Running your diesel for 5 sec and dieing, as you know, has nothing to do with your tractor's electrical system (no electricity involved in the diesel process) unless you have an electrical fuel shut off valve (mine are manual dash levers you pull to kill. But if you subsequently attempt to start it and nothing happens, it's not the diesel ckt. So divide and conquer. So, you need do some looking and supply us with more info and we can sharpen your sword. PS If you have a 24 volt system, the key switch is one complicated honey and could have, over the years, worn out. Even if it is not 24 volt, the switch is a good place to suspect. And if you have an electrical diesel fuel supply switch and it is fed off power coming thru your switch, you have a common thread. No power (thru the switch) for running the starter and no power to allow diesel to flow to the engine. Mark
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather�s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
L35 Kubota
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|