Tractor Talk Discussion Board |
mf 245 hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by c. b. on May 09, 2003 at 13:11:56 from (66.175.188.136):
the mf 245 has a remote hydraulic control setup on top of housing in front of the seat. since i do not have any cause to use any remote hydrailic equip., i decided to take it off and replace it with the blank cover plate. before i did this the 3 pth worked ok. either using the remote control or the 3ph control. now the position control and/or the draft control does not work as well as it did. if you raise the position control to the up position, as the book states, it has a bad sounding noise in hydraulics and regardless of what you use [ position or draft control] it does not respond as i think it should. anybody with any ideas, i may have to put the remote back on. sorry for the long post. thanks to all.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|