Tractor Talk Discussion Board |
Re: Why is this?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve - IN on March 01, 2003 at 23:10:35 from (12.222.18.37):
In Reply to: Why is this? posted by Les...fortunate on March 01, 2003 at 15:08:56:
Les, Depends on the age of your vehicle. If it's newer - the guys who are saying digital lag are right. Why doesn't your computer boot faster after an upgrade? Same problem. A digital gauge will go rail to rail - that is, 0 to 5 volts for CMOS stuff. Heaven forbid you should pay more for faster processors that would do analog to digital conversions faster. As it is, you buy slow stuff than only sample the input from the analog to digital conversion of the gas tank at slow rates - because gas is burned at a fairly slow rate. Reset the thing -- turn it off, then on -- and you get a new boot, a new start on your sampling. They expect you'll know you've just put gas in and won't want to pay for a gauge that tells you what you already know. If you have an old gauge -- pre 80's or so -- the gauge is a volt meter. The float in the tank gives more or less voltage depending on resistance in the varistat (like a light dimmer) in the sensor. Problem is, those thing bounce up and down like crazy - so gauges for them are packed in grease to get a fairly sensible reading. My guess is that you have a digital system, so you need to reboot your computer to get a true reading. If that's no good - then you have to pay more for a faster analog to digital conversion to tell you what the best computer - your brain - already knows -- that you've refilled the tank. Steve
Follow Ups:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|