Tractor Talk Discussion Board |
Farmall M carburator
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmall Daddy on January 29, 2003 at 16:01:57 from (209.183.116.135):
Funniest thing I have ever ran into. Tore my M down last September {2001}, bored the motor out, replaced the head, assembled the motor. Thought I was done, until I got to that carburator. Got to it and all it wanted to do was flow over and out the air intake channel {where the air hose hooks on}. Put 3 brand new carb kits in it and it didn't work. Had the 2 smartest IH men I have ever known bend the float to the correct position. Didn't work. Did everything to it that me, my dad, and the two mechanics thought of and it still didn't work. Took it back the mechanic and let him test it for anything possible. Here a year and four months later, it still sets in the barn. Haven't got the carb back yet, but if doesn't work, what should I do? Any help is greatly appreciated.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|