Tractor Talk Discussion Board |
Re: Pulling stumps
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dumb and Dumber on November 24, 2002 at 00:01:05 from (216.212.40.219):
In Reply to: Pulling stumps posted by TOM inFL on November 23, 2002 at 21:39:08:
I can't believe all this about pulling stumps. I was going to relate a story about how a guy north of here got killed using a tug strap, but it occurs to me that this stump pulling thing must be some kind of macho deal, so I say...go for it! Me personally, I've got a chain saw and cut at ground level and treat with Tordon and in a couple of years, you'd never know a tree was there. Anyway, the trees around these parts don't pull very easy anyway, I'd say if you've got anything over 8 or 10 inch diameter, it would take a heck of alot more than some antique tractor to pull anyway....well, on second thought, maybe not if you spent a half a day jerking on it from this side and that side, rearing the front of the tractor up, and digging holes where the tires spin. To all you stump pullers, make sure your life insurance is paid up, and get out there and jerk the darn things out of the ground.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|