|
Tractor Talk Discussion Board |
Hay Mower, Bar Cutter Replacement Question?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BlueLite on May 20, 2002 at 18:34:28 from (209.226.212.151):
I have an old seven foot hay mower and I'm going to relace the cutter blade and bar assembly. The "V" shaped blades are riveted in a series along the bar. My question concerns the 6 hold down fingers that presses the blades against the point cutter beds. Should they be holding down tight or just a bit loose? Should there be a space between it and the blades? Is there a special method of insuring correct pressure. Should I hard face the contact points with a welding rod to help prevent wear.? Thanks.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
On the Road with Dave Gohl: Deere Departed Friend - by Dave Gohl. Have you ever had to part with a dear friend? It's not easy. If it's due to death, your feelings could be in disarray for days, months or even years. Even now after almost 4 years, I still miss my dad. I remember when I was a kid my dad sometimes would tuck my brother and I in at night and we would ask him questions about his childhood on the farm. To this day, it's some of the best stories I've ever heard. And now, I'm so glad that I asked those questions, and if I were a little smarter i
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
