Posted by caterpillar guy on August 29, 2022 at 14:31:11 from (47.26.95.42):
In Reply to: 584IH hyd runs hot posted by Wbalcorn on August 29, 2022 at 14:00:41:
Well since you changed oil and filter that should solve that part of the equation so now have you cleaned out the oil cooler itself so you can see through the coil. If not that's a start . I would also take the shims out you put in and see where you are then. Since you say you had the MCV all apart did you happen to oil the o-rings as you installed them so they can slide easily in their bores? If not that could be a possible thing. Also do you know if the oil cooler is clear to circulate it doesn't take a lot of pressure to circulate the oil cooler circuit. Though it has about 300 PSI if I remember correctly. This is all based from the 574 we have and have worked on over the last 40 years or more.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Generators - by Chris Pratt. As a companion to the articles on three-brush and two-brush generators, it seemed fitting that we should provide our readers with a description of how a generator works in lay terms. The difficulty with all those "theory of operation" texts is that they border on principles of electricity or physics and such. Since I know nothing of either, you will have to put up with looking at the common sense side of how generators work which means we "
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
