Posted by NY 986 on August 07, 2021 at 18:10:57 from (67.249.255.74):
In Reply to: second cutting is done posted by formerly ny bill on August 07, 2021 at 16:09:05:
Still first cutting out around here. I've been trying to get wheat finished but Tuesday I could barely get enough through (due to being tough) the combine to take a sample to the elevator. 18.5 percent moisture. Finally was able to get rolling Thursday so now I have enough to load a semi. Wanted to cut wheat again today but the soybeans desperately needed spraying in one field as wet ground conditions interfered until today. I keep saying next year will be better but now I will just keep my mouth shut. The state of NY was nice enough to outlaw dicamba use after July 1 so another wrinkle in this year. 2-4D beans for next year I guess. When I try to count on pre-emerge chemicals the time to apply gets fouled up one way or another. Time to check my Powerball numbers.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Clutch Overhaul Tips - by Greg Sheppard. I got my 1964 Oliver Model 550 (serial 141-139-519) second-hand and used it for several years before the clutch began to slip. After taking up the pedal linkage several times I saw it was going to take more than that. The engine had been leaking oil at the rear seal and I suspected
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
