Posted by perryjosh64 on December 12, 2020 at 19:21:26 from (71.28.255.1):
Folks this is round 2 on ongoing issue. 1964 Ford 2000 4 cyl gas tractor. Tractor died awhile back while mowing like out of gas. Ive cleaned the tank/fuel lines, replaced the carburetor and spark plugs. New gas in tank, good flow from tank to carb. Engine will turn over but will not start. Sometimes it will crank and run for a few seconds then dies. After it dies or while trying to crank gas will leak out bottom of carb or air intake port. Ive posted about this before and some folks said could be bad switch, resistor, coil or something to do with electrical? Issue is tractor wont run long enough to do some of the tests they recommended.
Sssooo ANY recommendations of why tractor wont crank/run and how to test the electrical (switch/resistor/coil/etc) if tractor wont run long enough for normal tests?
FYI, dont know if this is important or not but when changing spark plugs I looked into plug holes and there is black grease/oil on backside?
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
