Posted by Andy R on February 29, 2020 at 11:53:37 from (208.126.193.44):
I have some used JD 7000 planting unit double disk openers that I am considering putting on the JD 7000 double disk fertilizer openers. The bearing fits perfectly. Yes, I know the opener blade diameter will have to be worn down or machined down enough to fit. Always wondered why the John Deere double disk openers on the fertilizer units used the thick cast hub and the openers on the seed units used the thinner pressed hub. Primary reason might be that the fertilizer openers would loose their dust caps working so close to the ground if using ones similar to the seed openers. Also, possibly since the fertilizer opener might be running deeper, the thicker cast hub may provide more support to the opener and not flex like the thinner pressed hub. I have seen worn seed openers on the fertilizer units before and they seem to work fine. Any thoughts other than the two that I can come up with? Thanks.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.