Posted by Stonan on December 26, 2019 at 04:19:25 from (134.209.25.158):
Hello everyone. This week My blood pressure is still up and the maxxums is down.
When I turn the steering when moving forward or backwards drive is lost, unless very high revs are used. ( This causes a bit of bother when reversing into the shed ).
So I started by changing hyd. canister filter and cleaning sump pre filter. I cut open the canister filter ( just to see) and it was full of metal fileings and a little bit of other rubbish my magnet would'nt pick up.
So I stopped there and sent it off to the menders.
5 weeks later I got it back with a BIG bill for lots of parts and The dam thing still would not reverse around the bend into the shed,
BUT THEY SAID IT WAS DEFINATLY FIXED.
There mechanic came and put pump tester on and said FLOW AND PRESSURE OK but pump must be weak and needs a new one BIG MONEY.
I then searched the internet as a friend said he had seen something about this and I found this site with the hyd. diagram from Richard.
SO MY QUESTION IS. HAS ANYONE GOT AN EASY TO FOLLOW HYD . DIAGRAM I CAN USE SO I CAN CLEAN AND CHECK ALL THE LINES PLEASE
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
