I am growing CBD hemp here in KY. One acre. Our processor wanted us to grow it under plastic mulch, with drip tape irrigation. He provided clones(all female), the mulch layer and water wheel setter/transplanter. He wanted experienced tobacco growers, able/experienced with the hand labor that comes with tobacco. And able to spend a lot of time with the crop. We are going to harvest by hand and hang/house it like tobacco. And hand strip it. No chemicals for weeds at all-trying to stay organic. We are shooting for 11% or higher CBD content, with less than .3% THC. 27.7% less than marijuana. Hemp at less than 10% CBD is low quality, and hard/less profitable to extract the CBD. I do not see how anyone could raise it for CBD in a large acreage such as the 450 mentioned. Male plants have to be destroyed so they do not pollinate the females-where the bud(which contains the CBD) comes from. We also don't want seeds either. As far as does CBD work? YES IT DOES!! I take it daily, and it helped with all my aches and pains, and the arthritis in my hand. I would dread going back to taking all the pain meds(over the counter) that I used to take, which did not help enough. Plus I can take them and CBD and get relief when needed, after overdoing it. Mark.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let�s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
