|
Tractor Talk Discussion Board |
Re: Farmall A model Throttle linkage.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ScottyNY on November 26, 2001 at 15:30:48 from (128.59.6.157):
In Reply to: Farmall A model Throttle linkage. posted by Herman on November 26, 2001 at 14:26:37:
Did this come up suddenly, like without changing anything? i.e. did it run and something has broken, or has it been worked on and and not got put back right. Does it run? If so, fast or slow? If the throw on the throttle lever is good from low to high throttle, I'd look first at the linkage on the carb side. Disconnect the turnbuckle from the governor rock shaft and check the adjustment. With the throttle lever back at the seat all the way forward (full throttle), push both the governor rockshaft and the rod linking it to the throttle lever on the carb as far back as they will go, the turnbuckle should be adjusted to line up so that the link pin slides right back into the governor rockshaft. Hope this helps. Let us know how you make out.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
