|
Tractor Talk Discussion Board |
breaker points and condensor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by vernon on October 11, 2001 at 10:07:03 from (206.221.230.209):
Recently I overhauled a MH with an autolite distributor. It ran good for a while but now I have a problem getting fire to plugs. There was a 12 volt conversion with purchased wiring harness. All directions were followed I used a resistor with a new coil to get the ohms between 2.7-3.3. I also put a new distributor, cap rotor button and plugs in it. I have since bought new copper core wires another new cap, a coil with the correct resistance without the resistor, and replaced the distributor with no luck. The coil wire fires but the spark plug wires won't. The points look okay. Could the condensor be the problem since it was designed for a six volt system? Need help I running out of stuff to replace.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Show Coverage: Argyle and Mt. Pleasant Labor Day Weekend Shows - by Cindy Ladage. The last fling before summer fades into fall and we get busy in the fields are the annual Labor Day tractor shows. Beginning on September 5th and running through the 7th, the Argyle Antique Gas and Engine Show is held at the Argyle State Park. Located in West Central Illinois, the pine forest was the setting for the opening of the 22nd show. This year we decided to try to sell a few tractor parts, literature and wrenches to offset my husband's buying sprees. Saturday
... [Read Article]
Latest Ad:
65 massey ferguson diesel
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|