Posted by pburchett on December 16, 2018 at 18:52:08 from (12.182.196.81):
I currently have a Kubota MX 5200 HST 4x4 tractor with front end loader and implements. Total weight with loader and an implement on the rear is about 7000 lbs.
My neighbor is going to buy my 7000 lb car hauler and cattle racks so I am going to use that money to purchase a heavier trailer.
I have 2 options for trailers near me that look promising: One which is this North Shore trailer (2 hrs away). Could I get this trailer nit-picked by the YT-DOT or any other person with experience and keen eyes?
I’m going to call tomorrow and get some specs on the trailer. I imagine the tires are Chinese and the axles may be as well. At this price it may have the thinnest c-channel available but with the 8 inch tongue and what looks to be a 6 inch frame it may be suitable for my load.
The other trailer is this 12,000 lb for $2995 but it does not look as good. To my untrained eyes it appears to be made of 5 or 6 inch c-channel.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
