Posted by jeffcat on May 08, 2018 at 05:44:41 from (76.116.234.200):
In Reply to: V Belt info posted by 37chief on May 07, 2018 at 21:57:38:
Those belts are called "Fractional" belts. Also cogged, notched, fractional horsepower, and a couple of others. They use them alot in HVAC work. They run quieter and are supposed to use less hp by bending easier. I have a little 20 inch on a large garage door lift. Use a 3/4 motor. Really does make a difference. Did some snooping around on the net and there are so many types of belts. Gates have always been super belts. Kevlar belts are super tough. Things that wear on belts over tighten, out of alignment, bent lips on pulleys, also rust in the grove of pulleys. I take a folded sheet of fine sand paper and turn the pulley and clean out the rust. Replace bent pulleys. If your pulleys are messed up you will see vibration. Belt flapping around. Should be smooth. Just what I have seen over the years.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.